![]() ![]() They seem not to relate to the config file. One question on the MindReader toolbar: How would I change the given contexts? I have installed the MindReader ribbon toolbar already a while ago and it works well too. Wonderful!! The error message is gone and the ribbon toolbar works well. Things tend to run much faster from the add-in. If there is a missing macro, I can add it. Manual mindjet mindmanager 2012 code#Initially I was just launching macros from it but now the code is converted to vb.net. Give the MindReader ribbon a try and see how it works for you. I wouldn’t move the ao macros as there are things like GyroQ that expect them to be there. Manual mindjet mindmanager 2012 install#Thanks Stefan - Can you download and install the latest version (1.0.005) and see how it works for you? I changed the error trapping in it and also programmed it to create the directory if needed and add the hello world files. Yes, the directory has already been created and was available.Ĭhanging the macros by myself is probably not a good idea -)) When you got the error, had you already created a “mymapmacros” directory? Maybe it was lack of the directory causing the error? I will try to trap that better or perhaps create it as part of first use. I wouldn’t want to move them all as some can’t be launched directly or might not be useful to you. Selected macros in the AO directory could be copied to the mymapmacros directory (leaving original in place), but you would need to edit code so that it could find the ao_common.mmbas file (‘#uses “./ao/ao-common.mmbas”). Hi Stefan - The most commonly used macros in the AO directory are now part of the MindReader add-in - I’d recommend you keep that tab! At this point I think the add-in will work without any macros in the AO directory (outlinker still needs a few). So I could group the most important ones.Īn “add-in manager” would be helpful. Is it possible to move your AO macros to that folder as well? My MM Ribbon is quite crowded now with all the add-ins I am using. This is very cool! In my case it starts with two error message “error trying to read macro files in C:\….” followed by “System.IndexOutOfRangeException ….” But then it works fine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |